A researcher measured the effect of pH on the activity of pepsin, a digestive enzyme. The results are shown below:
pH | Enzyme Activity (% of maximum)
1.0 | 85
2.0 | 98
3.0 | 72
4.0 | 41
5.0 | 18
6.0 | 5
At which pH is pepsin most active?
- A4.0
- B6.0
- C1.0
- D2.0Correct
Why D is right
The highest enzyme activity (98% of maximum) occurs at pH 2.0, indicating that pepsin functions optimally in strongly acidic conditions, consistent with its role in the stomach. The data and relationship in the passage point to this result more directly than the other choices.
Why the other 3 choices miss
- A
- Incorrect because pH 4.0 yields only 41% activity, well below the maximum observed.
- B
- Incorrect because pH 6.0 yields the lowest activity (5%), indicating pepsin is nearly inactive at this pH.
- C
- Incorrect because pH 1.0 yields 85% activity, which is lower than the 98% activity observed at pH 2.0.
Experiment 7: A student tested the effect of substrate concentration on enzyme reaction rate using amylase (a starch-digesting enzyme). The student kept amylase concentration constant and varied starch concentration, measuring product formed per minute.
Starch Concentration (g/L) | Reaction Rate (μmol product/min)
1 | 10
2 | 19
4 | 34
8 | 52
16 | 68
32 | 75
64 | 78
Which conclusion is best supported by these results?
- AReaction rate is not affected by substrate concentration above 16 g/L.
- BReaction rate approaches a maximum (Vmax) as enzyme active sites become saturated with substrate.Correct
- CReaction rate peaks then decreases at very high substrate concentrations.
- DReaction rate increases indefinitely as substrate concentration increases.
Why B is right
The data show progressively smaller gains in rate as substrate increases: from 32 to 64 g/L, rate increases only from 75 to 78 μmol/min. This leveling off occurs because enzyme active sites become occupied (saturated), limiting the maximum possible rate — the Michaelis-Menten Vmax concept.
Why the other 3 choices miss
- A
- Incorrect because the rate does still increase above 16 g/L (from 68 to 75 to 78 μmol/min), just at a decreasing rate, so it is not entirely unaffected.
- C
- Incorrect because the rate does not decrease at high concentrations — it continues to increase but at a slower and slower rate, approaching a plateau.
- D
- Incorrect because the data clearly show diminishing returns and the rate appears to be approaching a plateau, not continuing to increase indefinitely.
A biochemist measured the rate of cellular respiration in yeast at different temperatures by monitoring CO2 production per minute.
Temperature (°C) | CO2 Produced (mL/min)
10 | 0.8
20 | 2.1
30 | 4.7
37 | 6.3
45 | 3.9
55 | 0.4
What is the most likely explanation for the decrease in CO2 production above 37°C?
- ARespiratory enzymes denature and lose function at high temperatures.Correct
- BYeast cells run out of glucose substrate at higher temperatures.
- CCO2 becomes more soluble in water at elevated temperatures.
- DYeast switch from aerobic to anaerobic respiration above 37°C.
Why A is right
The sharp decrease in CO2 production above 37°C indicates that the enzymes driving cellular respiration lose their three-dimensional structure (denature) at high temperatures, reducing their catalytic function and thus CO2 output.
Why the other 3 choices miss
- B
- Incorrect because the experiment would control for glucose availability; substrate depletion would not show a sharp temperature-dependent decrease.
- C
- Incorrect because increased CO2 solubility would cause a gradual, predictable reduction, not the sharp peak-and-decline pattern, and this effect is minor in physiological ranges.
- D
- Incorrect because anaerobic respiration also produces CO2 (in fermentation), so switching pathways would not explain the large drop in total CO2 production.