Skip to content
ACT · Science

Ohm's Law

Ohm's Law appears in 3 reviewed ACT questions and sits in Science. Below are worked examples showing exactly how the exam tests it, with the answer marked and every distractor explained.

How Ohm's Law is tested

Example 1Medium
Experiment 3: A student set up four identical electric circuits, each with a 12-volt battery and a single resistor. The student varied the resistance and measured the resulting current. Circuit | Resistance (Ohms) | Current (Amps) 1 | 2 | 6 2 | 4 | 3 3 | 6 | 2 4 | 12 | 1 If the student added a fifth circuit with a resistance of 3 ohms and the same 12-volt battery, what current would be expected?
  1. A6 amps
  2. B2 amps
  3. C3 amps
  4. D4 ampsCorrect

Why D is right

The data follow Ohm's Law: Current = Voltage / Resistance = 12 V / 3 Ω = 4 amps. This is consistent with all four data points in the table. The data and relationship in the passage point to this result more directly than the other choices.
Why the other 3 choices miss
A
Incorrect because 6 amps corresponds to a 2-ohm resistor (Circuit 1), not a 3-ohm resistor.
B
Incorrect because 2 amps corresponds to a 6-ohm resistor (Circuit 3), not a 3-ohm resistor.
C
Incorrect because 3 amps corresponds to a 4-ohm resistor (Circuit 2), not a 3-ohm resistor.
Example 2Medium
Experiment 5: A physics student measured the current through a light bulb as voltage was increased, to test whether the bulb obeys Ohm's Law (constant resistance at all voltages). Voltage (V) | Current (A) | Calculated Resistance (Ω) 2 | 0.40 | 5.0 4 | 0.67 | 6.0 6 | 0.86 | 7.0 8 | 1.00 | 8.0 10 | 1.11 | 9.0 12 | 1.20 | 10.0 Does the light bulb obey Ohm's Law? What does the change in resistance indicate?
  1. AYes; the bulb obeys Ohm's Law because the resistance remains below 15 Ω throughout.
  2. BNo; Ohm's Law requires that resistance decreases with voltage, but the bulb shows the opposite.
  3. CNo; Ohm's Law requires constant resistance, but the bulb's resistance increases as it heats up at higher voltages.Correct
  4. DYes; the bulb obeys Ohm's Law because current increases with voltage.

Why C is right

Ohm's Law (V = IR) applies to ohmic conductors with constant resistance. The data show resistance increasing from 5.0 to 10.0 Ω as voltage rises. This is because the tungsten filament heats up at higher voltages, and the resistance of metals increases with temperature — a non-ohmic behavior.
Why the other 3 choices miss
A
Incorrect because Ohm's Law does not set a maximum resistance threshold; it requires that resistance be constant, which it is not in this experiment.
B
Incorrect because Ohm's Law does not require decreasing resistance with voltage; it requires constant resistance. The observed increase in resistance is the actual deviation from Ohm's Law.
D
Incorrect because while current does increase with voltage in a general sense, Ohm's Law specifically requires constant resistance, which the data do not show.
Example 3Medium
Students measured the voltage (V) across and current (I) through a diode and an ohmic resistor. Results for the diode: 0.0 V: 0 mA. 0.3 V: 0.01 mA. 0.5 V: 0.5 mA. 0.6 V: 5 mA. 0.7 V: 50 mA. Results for the resistor: 0 V: 0 mA. 1 V: 10 mA. 2 V: 20 mA. 3 V: 30 mA. 4 V: 40 mA. Which statement best describes the difference between the two components?
  1. ABoth components obey Ohm's Law, but the diode has a lower resistance.
  2. BThe diode obeys Ohm's Law; the resistor has exponentially increasing current at high voltages.
  3. CBoth components have nonlinear I-V relationships, but the resistor's nonlinearity is smaller.
  4. DThe resistor obeys Ohm's Law with a constant ratio of V/I; the diode has a nonlinear, exponentially increasing current above a threshold voltage.Correct

Why D is right

For the resistor, V/I = 100 Ω at all measured voltages — a constant ratio, consistent with Ohm's Law (linear I-V). For the diode, current increases exponentially with voltage above ~0.5 V (from 0.01 mA at 0.3 V to 50 mA at 0.7 V — a 5,000-fold increase for a 0.4 V change), consistent with the Shockley diode equation. This is highly nonlinear.
Why the other 3 choices miss
A
Incorrect because the diode clearly does not obey Ohm's Law; its current increases exponentially rather than linearly with voltage.
B
Incorrect because the data show the opposite — the resistor has a constant V/I ratio (Ohm's Law), while the diode is nonlinear.
C
Incorrect because the resistor's I-V data show a perfectly linear relationship with no nonlinearity; only the diode is nonlinear.

Studied alongside

Other concepts from Science.