Skip to content
AP Biology · Chemistry of Life

Enzyme kinetics

Enzyme kinetics appears in 61 reviewed AP Biology questions and sits in Chemistry of Life. Below are worked examples showing exactly how the exam tests it, with the answer marked and every distractor explained.

Enzyme kinetics describes how reaction rate changes with substrate concentration and other conditions. With enzyme amount fixed, the rate rises as substrate increases, then levels off at a maximum (Vmax) once every active site is busy.

Why it matters

Reading a rate-versus-substrate graph tells you what is limiting the reaction. On the flat part of the curve, the enzyme is saturated, so adding more substrate no longer helps. With other conditions held constant, raising the amount of enzyme is what increases the rate.

How the exam tests it

The most common question asks why the curve plateaus, and the answer is that all active sites are occupied. A few harder items go beyond the course framework and use kcat/Km to compare efficiency, or ask how inhibitors shift Vmax and Km. In those items, competitive inhibitors raise the apparent Km but leave Vmax alone, while noncompetitive inhibitors lower Vmax.

Don’t confuse it with

Students confuse a low Km with a slow enzyme, but Km measures how much substrate is needed to reach half of Vmax, so a low Km actually means the enzyme binds its substrate tightly.

Enzyme kinetics in real questions

Example 1Medium
A researcher is studying a newly discovered enzyme. When the researcher increases substrate concentration from low to very high levels while keeping enzyme concentration constant, the reaction rate increases and then levels off at a maximum velocity (Vmax). What is the best explanation for why the rate levels off?
  1. AThe enzyme has used up the cofactors it needs for catalysis, so the reaction slows once the cofactor supply runs out
  2. BHigh substrate concentrations lower the pH of the reaction mixture, causing partial denaturation of the enzyme
  3. CAll enzyme active sites are occupied by substrate, so added substrate cannot form more enzyme-substrate complexesCorrect
  4. DAt very high concentrations, substrate molecules bind non-specifically to the enzyme surface and inhibit its catalytic activity

Why C is right

At Vmax, every enzyme molecule's active site is occupied by substrate — the enzyme is saturated. Because the rate is limited by how fast the enzyme can process each substrate molecule (turnover number), adding more substrate cannot increase the rate further. The rate is now determined by the number of enzyme molecules, not substrate concentration.
Why the other 3 choices miss
A
Cofactor depletion would cause a gradual decrease in rate, not a plateau at Vmax; the standard Michaelis-Menten model assumes cofactors are sufficient.
B
Substrate molecules generally do not affect pH in typical enzyme kinetics experiments; pH is usually controlled by buffer solutions.
D
Substrate inhibition can occur at very high concentrations in some enzymes, but the general explanation for Vmax plateau is active site saturation, not nonspecific surface binding.
Example 2Harder
An enzyme has a kcat of 1000 s^-1 and a Km of 0.5 mM. A second enzyme catalyzes the same reaction with a kcat of 100 s^-1 and a Km of 0.01 mM. At very low substrate concentrations (much less than Km for both enzymes), which enzyme is more efficient?
  1. AEnzyme 1, because it has a higher kcat (turnover number)
  2. BEnzyme 2, because it has a lower Km (higher substrate affinity)
  3. CBoth are equally efficient because they catalyze the same reaction
  4. DEnzyme 2, because its kcat/Km ratio (catalytic efficiency) is higherCorrect

Why D is right

At substrate concentrations much lower than Km, the catalytic efficiency is best measured by the kcat/Km ratio (the specificity constant). Enzyme 1: kcat/Km = 1000/0.5 = 2000 mM^-1 s^-1. Enzyme 2: kcat/Km = 100/0.01 = 10,000 mM^-1 s^-1. Despite having a lower kcat, Enzyme 2 is more efficient at low [S] because its very low Km means it achieves near-maximal velocity at much lower substrate concentrations, resulting in a higher catalytic efficiency.
Why the other 3 choices miss
A
kcat alone measures maximum catalytic rate (at saturating substrate); at low substrate concentrations, affinity (Km) also matters. Enzyme 1's higher kcat is offset by its much higher Km.
B
While a lower Km does indicate higher substrate affinity, the correct measure of efficiency at low [S] is the combined kcat/Km ratio, which accounts for both affinity and catalytic rate.
C
Catalyzing the same reaction does not make enzymes equally efficient; kcat, Km, and their ratio (catalytic efficiency) can vary greatly between isoforms or different enzymes performing the same function.
Example 3Harder
Competitive inhibition and substrate binding follow similar kinetics because both involve the inhibitor and substrate competing for the same site. Which graph would most clearly distinguish competitive from noncompetitive inhibition?
  1. AEnzyme concentration vs. initial reaction rate
  2. BTemperature vs. enzyme activity at fixed [S]
  3. CpH vs. enzyme activity near the pH optimum
  4. DLineweaver-Burk plot: 1/v vs. 1/[S]Correct

Why D is right

A Lineweaver-Burk plot (1/v vs. 1/[S]) transforms the hyperbolic Michaelis-Menten curve into a straight line. In competitive inhibition, the lines for inhibited and uninhibited enzyme have different slopes and different x-intercepts (apparent Km changes) but converge on the same y-intercept (Vmax unchanged). In noncompetitive inhibition, the lines have the same x-intercept (Km unchanged) but different y-intercepts (Vmax decreases). The intersection pattern on the Lineweaver-Burk plot clearly identifies the inhibition type.
Why the other 3 choices miss
A
A graph of enzyme concentration vs. initial reaction rate shows a linear relationship for both uninhibited and inhibited enzyme; it does not distinguish between types of inhibition.
B
Temperature vs. activity curves at a fixed substrate concentration show the stability and optimal temperature of the enzyme; adding an inhibitor would shift the curves but would not reveal whether inhibition is competitive or noncompetitive.
C
pH vs. activity curves reveal the enzyme's pH optimum related to ionization of active site residues; they do not distinguish between mechanisms of inhibitor action.

Studied alongside

Other concepts from Chemistry of Life.