On this page · 5 sections
Section II of AP Chemistry is 105 minutes, seven questions, and exactly half your score. Three are long questions worth 10 points each. Four are short questions worth 4 points each. That is 46 raw points total, and every one of them is a separate line on a rubric that a reader checks off independently.
Split the clock before you write anything. A long question deserves 20 to 23 minutes. A short one deserves 6 to 8. That commits about 94 minutes and leaves you roughly ten in reserve. The four short questions hold 16 of the 46 points, and each is single-topic and self-contained, so they are the cheapest points on the paper. Losing one because a long question overran is the most expensive mistake available to you.
Readers do not score your answer as an essay and assign an impression. They hunt for specific pre-listed elements. On a titration of propanoic acid with NaOH, one rubric line is the net-ionic equation HC3H5O2(aq) + OH-(aq) -> C3H5O2-(aq) + H2O(l); writing the acid as dissociated H+ loses it, because propanoic acid is weak. Another line asks why ethanol boils at 78 C while dimethyl ether, the same C2H6O formula, boils at -24 C; the point is hydrogen bonding in ethanol, and "ethanol is more polar" does not earn it. A third wants a mass in grams with the unit written next to it. If the element is on your page you get the point, even if the sentence around it is clumsy. If it is missing, nothing else you wrote recovers it.
A calculator is permitted on Section II, and you have the periodic table and the equations-and-constants sheet throughout the exam. What you do not get is credit for unjustified correctness. On any part that says justify or explain, a right answer with no reasoning earns zero. Error carried forward is real but narrow: a wrong value carried into a later part that you set up correctly usually still earns that later part's point. It does not rescue a conceptual error. Reasoning that is self-consistent but chemically wrong scores zero, because the rubric line names the chemistry, not your arithmetic. Two mechanical rules cost points every year. Units are required on quantities you report. Significant figures are scored at only a limited number of designated points across the whole exam, so a rounding slip is cheap and a missing unit is not.
Units 3 and 8 carry the heaviest weight in the multiple-choice blueprint, roughly 18 to 22 percent for Unit 3 and 11 to 15 percent for Unit 8. Those figures describe Section I only. The free-response section is not blueprinted by unit at all, because each question deliberately mixes topics from several units, so no unit owns a fixed share of the 46 points. In practice acid-base chemistry and solution and particulate content do show up in Section II very frequently. Unit 3 material is intermolecular forces and their consequences: solids, liquids and gases including the ideal gas law and kinetic molecular theory, then solutions and mixtures, separation techniques, and spectroscopy.
At least one free-response question every year is lab-based, matching the hands-on lab requirement built into the course. It will ask you to design a procedure, defend a choice of equipment, or analyse data a student collected. Across the seven questions the same task types keep returning. You write balanced and net-ionic equations. You draw or read particulate diagrams. You give a Lewis structure, a molecular geometry, or an intermolecular-force comparison between two named substances. You run a calculation chain with the setup, the substituted values, and the units all shown. And you answer the standard error-analysis prompt: given a stated mistake, is the calculated value too high, too low, or unaffected, and why.
The steps
- 1
Split the 105 minutes before you write a letter
Three long questions at 10 points, four short questions at 4 points. Give each long question 20 to 23 minutes and each short question 6 to 8. That is about 94 minutes committed and roughly ten held in reserve.
Do the four short questions first if you tend to start slowly. Each is self-contained and worth 4 points for six or seven minutes of work, which is a better rate than a 10-point question that costs twenty-plus. Write a planned finish time next to each question number as soon as you open the booklet.
When the clock passes that time, stop mid-sentence and move. A long question abandoned at 8 of 10 points beats a short question you never opened.
- 2
Label every part by its command verb
AP Chemistry prompts are built around four verbs, and each names a different kind of rubric line.
"Calculate" wants the setup on the page. Write the numbers you substituted and the units they carry, as in (0.0250 L)(0.100 mol/L) = 2.50 x 10^-3 mol. A bare final number can lose the setup point even when the number is right.
"Justify" wants you to point at the specific data or structural feature the stem handed you. If the rate table shows the initial rate quadrupling when [NO] doubles, say exactly that, then conclude the reaction is second order in NO. Stating the conclusion without naming the number is not justification.
"Explain" wants a cause at the level of particles. Ethanol boils at 78 C; dimethyl ether, same C2H6O formula, boils at -24 C. The explanation is that ethanol has an O-H bond and hydrogen bonds to its neighbours, while dimethyl ether has no H attached to O and is held only by dipole-dipole and London forces, so less energy is needed to separate its molecules. "Ethanol is more polar" restates the difference instead of causing it.
"Draw" wants exactly the labels the prompt lists: charges, lone pairs, a stated number of particles, a key. A particulate drawing with the right particles and no charges shown loses the point.
- 3
Write equations as chemistry, not as bookkeeping
Almost every long question contains at least one equation line. Balance atoms and charge, then decide what gets split.
Split only strong acids, strong bases, and soluble ionic compounds into ions. Keep weak acids, weak bases, insoluble solids, gases, and water written as whole formulas. Leave spectator ions out entirely.
For NaOH titrated into propanoic acid, the net-ionic equation is HC3H5O2(aq) + OH-(aq) -> C3H5O2-(aq) + H2O(l). Writing H+ + OH- -> H2O instead is the most common way to lose that point, because propanoic acid is weak and barely dissociated. For HCl with NaOH, H+(aq) + OH-(aq) -> H2O(l) is correct. The difference is the strength of the acid, not the style of the answer.
Before moving on, check that total charge on the left equals total charge on the right. On the propanoic acid line it is -1 on both sides.
- 4
Run the calculation chain so each stage earns on its own
Long questions stack calculations: volume to moles, moles to moles through the mole ratio, moles to concentration or mass. Put each stage on its own line with a unit attached to every number. A reader scanning for the mole-ratio point needs to see the ratio applied, not infer it from a calculator result.
If an early number goes wrong, keep going. A value carried forward into a later part that you set up correctly usually still earns that later part's point. The limit matters: error carried forward covers arithmetic, not concepts. If you picked the wrong limiting reactant, or decided a weak base gives a pH below 7, every line built on that idea scores zero however consistent your algebra is.
Never leave a later part blank because an earlier one collapsed. Assume a plausible value, say in one clause that you are assuming it, and finish the chain.
- 5
Answer particle-level parts with a mechanism, not a label
Explanation points in AP Chemistry usually cash out as one of three things: which intermolecular force is present and why, what the particles are doing in a diagram, or which way an equilibrium shifts and what drives it.
For forces, name the force and the structural feature that creates it. Hydrogen bonding requires H bonded to N, O, or F. London dispersion strength rises with the number of electrons, which is why I2 is a solid at room temperature and Cl2 is a gas. Ion-dipole attraction is what pulls NaCl apart in water.
For particulate diagrams, count what you draw. A picture of 0.10 M HCl should show no intact HCl molecules, only H+ (or H3O+) and Cl-. A picture of 0.10 M HF at the same concentration should show mostly intact HF with a few ions, because HF is weak. The rubric checks the ratio you drew, not the neatness.
For equilibrium, name the stress and the response. Adding C3H5O2- to a propanoic acid solution shifts HC3H5O2 to the left in HC3H5O2 <-> H+ + C3H5O2-, so [H+] falls and pH rises.
- 6
Treat the lab question as its own genre
At least one free-response question every year is lab-based, because the course carries a hands-on lab requirement. It will ask you to design a procedure, choose equipment, or reason about data a student collected.
A design answer needs three things: the quantity you will measure, the equipment that measures it to the precision the task needs, and the calculation that turns the measurement into the requested value. Say "measure the mass of the dry filter paper plus precipitate on an analytical balance", not "weigh the product". Name a burette for titrant volume, a volumetric flask for preparing a standard solution, and a spectrophotometer set to the wavelength of maximum absorbance for a Beer-Lambert calibration curve.
The error-analysis prompt is close to guaranteed and has a fixed shape. A specific mistake is described, and you must say whether the calculated value comes out too high, too low, or unaffected, and justify it. Trace the mistake through your own formula. Rinsing a burette with distilled water and filling it without rinsing with titrant dilutes the titrant, so more volume is delivered, so the calculated moles of titrant and the calculated concentration of the analyte both come out too high. Adding extra distilled water to the flask holding the analyte changes nothing, because it changes neither the moles of analyte nor the moles of titrant needed. "Unaffected" is a real answer that appears on real rubrics.
- 7
Spend the last five minutes on units, blanks, and verbs
Three sweeps, in this order.
First, hunt for reported quantities with no unit. A correct number written naked is a lost point on chemistry you actually did. Significant figures are scored at only a limited number of designated points across the exam, so a sig-fig slip is cheap by comparison, but round to match your least precise given anyway.
Second, find every blank part and put something defensible in it. Blank scores zero with certainty; a correct setup carrying a wrong number often scores.
Third, reread each command verb and check you obeyed it. Did the "justify" part cite a number from the stem? Did the "draw" part include the labels asked for? Did the "calculate" part show substituted values? This sweep recovers more points than rewriting any single answer.
Worked through
A student titrates 25.0 mL of a solution of an unknown monoprotic weak acid, HA, with 0.100 M NaOH. The equivalence point is reached after 32.0 mL of NaOH has been added. After 16.0 mL has been added, the pH is 4.88.
(a) Write the balanced net-ionic equation for the titration reaction.
HA(aq) + OH-(aq) -> A-(aq) + H2O(l)
HA is weak, so it stays whole. Na+ is a spectator and is left out. Charge is -1 on each side.
(b) Calculate the initial concentration of HA.
moles OH- at equivalence = (0.0320 L)(0.100 mol/L) = 3.20 x 10^-3 mol mole ratio is 1:1, so moles HA = 3.20 x 10^-3 mol [HA] = 3.20 x 10^-3 mol / 0.0250 L = 0.128 M
Three separate rubric lines live in those three rows: the moles of titrant, the mole ratio, and the division by the original volume with a unit on the answer. Writing only "0.128 M" risks two of them.
(c) Calculate Ka for HA.
16.0 mL is exactly half of 32.0 mL, so this is the half-equivalence point. There [HA] = [A-], so pH = pKa + log([A-]/[HA]) collapses to pH = pKa. Therefore pKa = 4.88 and Ka = 10^-4.88 = 1.3 x 10^-5.
The sentence explaining that half-equivalence makes the two concentrations equal is the point. The number alone is not.
(d) Is the pH at the equivalence point greater than, less than, or equal to 7? Justify your answer.
Greater than 7. At the equivalence point all the HA has been converted to A-. A- is the conjugate base of a weak acid, so it reacts with water: A-(aq) + H2O(l) <-> HA(aq) + OH-(aq). That reaction produces OH-, so the solution is basic.
"Because a base was added" earns nothing here. The rubric wants the species and the reaction that generates OH-.
(e) The student rinsed the burette with distilled water and then filled it with the NaOH solution without rinsing it with NaOH first. Is the calculated value of [HA] too high, too low, or unaffected? Justify your answer.
Too high. The residual water dilutes the NaOH, so its true concentration is below 0.100 M. More volume must be delivered to reach the equivalence point. The student still multiplies that larger volume by 0.100 mol/L, which overstates the moles of OH-, so the calculated moles of HA and the calculated [HA] both come out too high.
The whole answer runs back through the formula in part (b). That is what an error-analysis justification looks like: name the affected measurement, follow it into the equation, state the direction.
Common mistakes
Restating an observation instead of explaining it. "Ethanol has a higher boiling point because its intermolecular forces are stronger" names no force and no structural reason, so it earns nothing.
Reporting a bare final number on a "calculate" part. The setup line with substituted values and units is frequently a separate rubric point from the answer itself.
Splitting a weak acid or an insoluble solid into ions in a net-ionic equation. HC3H5O2 stays whole; only strong acids, strong bases, and soluble ionic compounds are written as ions.
Dropping the unit on a reported quantity. A correct 0.128 written without the M is a lost point on chemistry you already did right.
Leaving a later part blank after an earlier one collapsed. Error carried forward lets a correctly set-up later part score with your wrong number, but only if you actually write it.
Letting a long question run to 35 minutes and never opening a 4-point short. The short questions pay roughly 0.6 points per minute; the long ones pay about 0.45.
Checklist
- Can you state, without checking, how many minutes each long and each short question gets, and write a finish time beside each question number?
- Can you write the net-ionic equation for a weak acid neutralised by a strong base, and say why the acid stays whole?
- Can you name what "justify", "explain", "calculate", and "draw" each demand, with a chemistry example of each?
- Can you lay out a two-stage calculation chain with a unit on every number, so a reader finds the mole-ratio point without hunting?
- Can you explain a boiling-point difference by naming the intermolecular force and the structural feature that produces it?
- Can you draw particulate diagrams of a strong acid and a weak acid at the same concentration and defend the ratio of particles you drew?
- Can you take a described lab error, run it through your own formula, and say whether the result is too high, too low, or unaffected?
- Can you finish with a sweep that catches missing units and blank parts before time is called?