Skip to content
AP Statistics · Exploring One-Variable Data and Collecting Data

Median

Median appears in 47 reviewed AP Statistics questions and sits in Exploring One-Variable Data and Collecting Data. Below are worked examples showing exactly how the exam tests it, with the answer marked and every distractor explained.

How Median is tested

Example 1Medium
In a data set with values 5, 8, 12, 15, 20, 24, 30, 35, 40, and 100, the value 100 is identified as a potential outlier. If 100 is removed from the data, which summary statistics change the most?
  1. AThe mean and standard deviation change the most.Correct
  2. BThe mean and IQR change the most.
  3. CThe median and standard deviation change the most.
  4. DThe median and IQR change the most.

Why A is right

The mean uses all values in its calculation and is pulled toward extreme values. Removing 100 would substantially decrease the mean. The standard deviation also uses all values and measures deviation from the mean; removing an extreme value decreases it significantly. The median and IQR are resistant measures and change little when an outlier is removed.
Why the other 3 choices miss
B
The IQR is a resistant measure based on quartiles. Removing one extreme value would have minimal effect on Q1 and Q3, thus little effect on IQR.
C
While the SD is non-resistant, the median is resistant to outliers. The median would shift very little after removing 100.
D
The median and IQR are resistant to outliers. Removing a single extreme value causes minimal change in these measures.
Example 2Medium
In a right-skewed distribution, which ordering of measures of center is correct?
  1. AMode < Median < MeanCorrect
  2. BMean = Median = Mode
  3. CMean < Median < Mode
  4. DMedian < Mode < Mean

Why A is right

In a right-skewed (positively skewed) distribution, the mode is at the peak (usually the leftmost high point), the median is pulled right by the tail but is resistant, and the mean is pulled furthest to the right by the extreme high values. The general ordering is Mode < Median < Mean.
Why the other 3 choices miss
B
Mean = Median = Mode holds only for perfectly symmetric distributions. Right-skewed distributions are by definition asymmetric.
C
Mean < Median < Mode is the pattern for LEFT-skewed distributions, where the tail extends to the left and low values pull the mean downward.
D
Median < Mode < Mean is not the typical ordering for any standard skewed distribution. In right-skewed data, the mode is at the peak on the left, below both the median and mean.
Example 3Medium
Which characteristic of a histogram most directly helps you estimate the median of a distribution?
  1. AThe bar with the greatest frequency, which marks the center.
  2. BThe leftmost bar, where the lowest class of values is shown.
  3. CThe height of the tallest bar.
  4. DThe point that splits the total area in half.Correct

Why D is right

The median is the value that divides the distribution into two equal halves. In a histogram, this corresponds to the value where 50% of the total area falls to the left and 50% falls to the right. To estimate the median, find the vertical line that splits the histogram's total area in half.
Why the other 3 choices miss
A
The bar with the greatest frequency identifies the mode, not the median. In a skewed distribution, the modal bar is often not where 50% of the area falls.
B
The leftmost bar represents the minimum or lowest class of values, not the median.
C
The height of the tallest bar corresponds to the mode (most frequent value), not the median.

Studied alongside

Other concepts from Exploring One-Variable Data and Collecting Data.